Depending which mode you are using, you will see some different setup options:

PPM on, settings

• Assign a separate control to each of the 12 "output channels"
• You can toggle to second view to get a quick overview of all output channels

Teacher, settings

• Assign the control which will be replaced by the "input channels".
• If needed you can reverse a "input channel", Check the blue bar for information.
• Press "Start Calibration" to perform a calibration. The Student transmitter must be connected. The input of each channel is set to 0% for center and to 100% for maximum input value. Follow the instructions on the screen to perform a calibration.

  NOTE: Calibration button only appears if there is a valid PPM signal input.

• You can toggle to second view to get a quick overview of all channels Student,

Student, settings

• Assign a control to each of the 12 "output channels".
• You can toggle to second view to get a quick overview of all output channels

Pilot, settings

• Assign a control which will be the backup for the "additional controls/channels". Use fix values as a failsafe position.
• If needed you can reverse a "Additional remote channel", Check the blue bar for information.
• You can toggle to second view to get a quick overview of all remote channels

Operator, settings

• Assign a control to each of the 12 "remote channels" .
• You can toggle to second view to get a quick overview of all remote channels Teacher Student Setup