Servo Synchronisation - this menu helps you to adjust servo groups and also let you run and setup the automatic synchronization (the Auto Syncronisation is only available at the Gizmo receiver series)
On the left there are some general options and on the right you see the servos of the group.

• Group, tab and choose the group which you want to configure. The name of the group is based on either the Servos are assigned via the "Graphic View", or if you created the group by yourself.
  • If created by the "Graphic View":
    • first character indicates:
      L = left wing / R = right wing / E = elevator / R = rudder
    • second character indicates the position:
      • at the wing it is a number, 1 starts from the middle
      • at the tail it is a letter, C = Center / L = left side / R = right Side
  • If you added the group manually there are simple letters (from A to N ) for each group.
• Accuracy, there are 3 different options:
  • Easy, each 4th point on the “slave” curve will be synchronized
  • Standard, each second point
  • Fine, all possible points

    PLEASE NOTE that the fine accuracy will run the automatic synchronization for a long time.

• Max. Current, here you have to adjust the maximum current during the automatic sync procedure. We recommend according to the used servos different values.
  • Analog servo "standard" : 1.0 A
  • Analog servo "power" : 1.5 A
  • Digital servo "standard" : 2.0 A
  • Digital servo "power" : 3.0 A
  • Digital servo "extreme power" : 5.0 A

• Plug, the physical servoplug number.
• Servo, the name of the servo just for info.
• Rev. tab here and change the direction of each slave servo separately.

  NOTE: Check this before you connect the linkages if the servos are attached to the same surface! Use the "Check Direction" button to control it.

• Edit, tab here and enter the deviation curve of the slave servo by yourself.