Help
-- V

  • Model Name: Just tab and use the keyboard to enter the name.

  • Choose a Category (this feature will be available soon)

  • Choose an Image (this feature will be available soon)

  • Info Text: Do notes regarding your model.

  • The resolution for the percentage values during programming this model will be
    • very fine (0.1% = 4000 steps ) or
    • middle (0.5% = 800 steps ) or
    • normal (1% = 400 steps ).

  • F. Preselect: This is the function preselect mode for the setup wizard. Please consider that this option is only used whenever you are creating a new model with the “setup wizard”. There are two different ones:
    • Basic: each wing surface will be added to one aileron and one flap function
    • Advanced: each wing surface pair will get its own aileron and flap function

  • Tail Type; choose between the three different options, please use delta for only wing models. Please consider that this option is not editable later.
    • Normal: Cross-tail and T-tail configuration
    • V-Tail: The elevator and rudder function will be linked to both tail surfaces
    • Delta: The elevator and aileron function will be linked to the wing surfaces

  • Number of (moving) control surfaces: The geometric configuration is visualized by the graphic on the right. Please consider that this are really only the moving surfaces and not the amount of servos. The servo plugs will be linked to each surface under the option “Servo Configuration / Graphic View”. Please consider that this option is not editable later.