Servo Assignment - link servos to functions
Press the “PLUS” button to add servos or press the “TRASH” button to remove servos. If the function was created with the “Setup Wizard” you will see the “Servo configuration GRAPHIC view” button.
The servo list contains several columns:

• Plug, the physical plug number at the receiver, only for your information.

• Servo, only for information (go to servo configuration for editing)

• Group, only for information and shows the group or if handled by the graphic view the location.

• L/R, information if the servo is physically on the left (L) or right (R) side of the model, this information is mainly needed for the aileron differential feature.NOTE: If handled by the graphic view you cannot edit this option.

• -Travel+, here you can adjust the 2 end point values for each servo only for this designated function. We recommended to use the travel to reverse the direction of the servo! Move the control will mark the side of the servo-travel blue.NOTE: The normal “-Travel+” is deactivated if you adjust a curve. By pressing “Curve Reset” you delete the curve and the 2 end point values can be adjusted again.

• Curve, tab the “CURVE” button to adjust a curve for this servo.