There are 2 different views for this screen. You can switch between them by tabbing on the 2 buttons on the top right corner. NOTE: All servos which are configured and assigned via the “graphic view” are only editable in the “graphic view”.

The “list view” shows all servos according to the type of receiver. The list is sorted by the first column , which is the phyisical plug number at the receiver. Then there are more columns:

• Servo, here you can name your servoplug. For example you could describe the location of the servo inside your model.

• Group, this gives you the option to create servogroups. To adjust the slave servos you have to go to the “Synchronize” menue.

• Center, tab on the value and adjust the center position of the servo with the slider/numpad popup. tab on the “CHECK” to confirm or tab on the “UNDO” to undo the changes and set the value back to the initial value.

• - Limit + , use this two values to set a maximum value for both directions of each servo. The popup includes a “TEST” button. If activated the servo will move very slow to the adjusted maximum value. Please make sure that the servo can reach this position without mechcanical blocking. NOTE: This limit will is a absolut limit which the servo will never exceed.

• Info, choose a frame rate for this servoplug. Please make sure that the attached servo can handle the frame rate. The default value is 18ms and this rate matches all common used servos.

The “graphic view” shows the model top view, which you created at “Model Configuration” and allows the “setup wizard” to create functions which are already linked to the designated servoplug or plugs. You can always change the assigned servo plug, but be aware that the values for center and limits are reset to default.

• Use the zoom buttons to navigate to the surface you want to adjust.

• Tab one of the blue surfaces and you will enter a popup menue. Now you can assign a servoplug to this surface by pressing the “PLUS” button. Or delete a plug by tabbing the “TRASH” button. NOTE: All servos which are grouped via the “list view” are not selectable.

• The group option is now handled automatically and the index shows the position if the servo. When you select two or more servoplugs to one surface the “Synchronize” button will be activated. This menue will allow you to adjust curves for each “slave” servo.

• As a default, and only if you have choosen at least one wing surface, all wing surfaces are assigned to the aileron and flap or aileron and elevator function. You can uncheck this if you want.